CUMMINS QC5200 Guía de usuario descargar pdf (Pagina 59)

parameter, as described later. Note that a maximum of 35 QC

Configurator parameters can be configured to be displayed on

the Q

UICK

HECK

Monitor screen.

Faults Selector

The Faults selector controls the faults displayed on the

UICK

HECK

Fault Screen. The Default list configuration is

set to view the faults from Engine #1. In order to view the faults

from a different subsystem, such as a Transmission or Brakes,

tap the Faults selector pull-down list to select that subsystem.

Note that component ID information (i.e., Make, Model, and

Serial No.) will also appear at the bottom of the Q

UICK

HECK

CE Equipment screen when selecting a subsystem other than

Engine #1 to read faults (Engine #1 component ID information

always appears near the top of the Q

UICK

HECK

Equipment

screen).

Subsystem Screens

The subsystem screens can be navigated through by use of the

four tabs located near the top of the screen, labeled: Engine,

Trans., Brakes, and Vehicle. Each tab has associated with it a

number of parameters that pertain to that label. For example,

parameters associated with a transmission will be found on the

Trans. screen.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 88 89

Sin comentarios

CUMMINS QC5200 Guía de usuario Pagina 59