CUMMINS N14 Especificaciones descargar pdf (Pagina 409)

100

101

Accessory Drive - Cleaning and

Inspection for Reuse (09-01)

Cleaning

Remove all gasket material from surfaces (1) and (2).

Clean the exterior of the drive with solvent. Dry with com-

pressed air.

Inspection

Measure the drive shaft end clearance at the end of the

shaft for accurate measurement.

Drive Shaft End Clearance

mm in

0.10 MIN 0.004

0.225 MAX 0.009

NOTE: If the shaft end clearance does not meet these spec-

ifications, rebuild or replace the drive unit. Refer to Acces-

sory Drive - Rebuild (09-02).

Visually inspect the housing for cracks or damaged mount-

ing holes.

Visually inspect the drive gear (1) for damaged teeth.

Visually inspect the shaft (2) for scratches, scoring, or

other damage.

Accessory Drive - Rebuild (09-02)

Disassembly

Remove the special capscrew and washer.

Caution: Install a 3/8-16 X 3/4-inch capscrew (1) without

the washer into the shaft to prevent damage to the shaft

while the gear is being removed.

Drive Units Accessory Drive - Cleaning and Inspection for Reuse (09-01)

N14 Page 9-5

1 2 ... 404 405 406 407 408 409 410 411 412 413 414 ... 586 587

Comentarios a estos manuales

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificaciones Pagina 409

Comentarios a estos manuales