CUMMINS N14 Especificaciones descargar pdf (Pagina 65)

100

101

Use main bearing cap puller, Part No. ST-1178, to re-

move the caps. The service tool must be centered on the

main bearing cap.

NOTE: Use a pencil or scribe to mark the bearing shells with

the journal number from which they were removed if they are

to be used again or if failure analysis is required. Mark the

bearing on the back side or in the locating tang.

Remove the lower main bearing shell from the crankshaft

journal.

Remove the dowel ring.

Remove the thrust bearings from the No. 7 cap.

Mark these bearings as the front and the rear thrust

bearings.

Caution: Do not damage the crankshaft when removing

the thrust bearings.

Use a blunt tool to remove the upper thrust bearings.

Mark these bearings in the notched area as the front and

the rear thrust bearings.

NOTE: If necessary, slide the crankshaft to the front or to the

rear to allow the thrust bearings to be removed.

Engine Disassembly (00-01) Crankshaft - Removal

N14 Page 0-45

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 586 587

Comentarios a estos manuales

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificaciones Pagina 65

Comentarios a estos manuales