CUMMINS N14 Especificaciones descargar pdf (Pagina 413)

100

101

With the gear/shaft assembly supported in an arbor press,

use a mandrel to install the coupling. Push the coupling

until it touches the clamping washer.

NOTE: The splined-type coupling must be installed with the

relieved area facing the clamping washer. The hub-type

coupling must be installed with the drive tangs facing away

from the clamping washer.

Caution: The capscrew must contain an oil drilling if an

air compressor is to be mounted on the engine.

Install the washer and the capscrew.

Torque Value: 47 N•m [35 ft-lb]

Install the straight thread o-ring plugs in the housing.

Torque Value: 5 N•m [47 in-lb]

Rotate the shaft to check for correct assembly.

Measure the drive shaft end clearance at the end of the

shaft for accurate measurement.

Drive Shaft End Clearance

mm in

0.10 MIN 0.004

0.225 MAX 0.009

Drive Units Accessory Drive - Rebuild (09-02)

N14 Page 9-9

1 2 ... 408 409 410 411 412 413 414 415 416 417 418 ... 586 587

Comentarios a estos manuales

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificaciones Pagina 413

Comentarios a estos manuales