CUMMINS N14 Especificaciones descargar pdf (Pagina 85)

100

101

Caution: The rod cap alpha-numeric characters must

match the alpha-numeric characters on the connecting

rod and must be installed with the characters aligned to

prevent damage to the connecting rods and the crank-

shaft. The locking tang of the connecting rod cap must

be toward the camshaft side of the cylinder block.

Install the connecting rod caps and the capscrews.

Tighten the rod capscrews in alternating sequence to the

following torque values:

• Tighten to 102 N•m [75 ft-lb].

• Tighten to 264 N•m [195 ft-lb].

Measure the connecting rod side clearance. The side

clearance must be between 0.114 mm [0.0045-inch] and

0.51 mm [0.020-inch].

NOTE: The connecting rod must move freely from side to

side on the crankshaft journal. If the rod does not move

freely, remove the rod cap and make sure the bearing shells

are the correct size. Check for dirt or damage on the crank-

shaft and the bearing shells.

Rear Cover - Installation

Use a clean cloth to clean the crankshaft flange.

NOTE: Do not use lubricant to install the seal. The oil seal

must be installed with the lip of the seal and the crankshaft

clean and dry to provide a correct oil sealing surface and to

provide maximum engine life.

Install a new gasket on the cylinder block.

Install the rear cover and the eight capscrews and wash-

ers. Tighten the capscrews just enough to hold the rear

cover in position.

Engine Assembly (00-02) Rear Cover - Installation

N14 Page 0-65

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 586 587

Comentarios a estos manuales

Jesus Morales 03 Apr 2025 | 23:07:31

Perfect..

CUMMINS N14 Especificaciones Pagina 85

Comentarios a estos manuales